LTC3230
OPERATION
Power Management
The LTC3230 uses a switched capacitor charge pump to
boost CPO to as much as 2 times the input voltage up to
5V. The part starts up in 1x mode. In this mode, V IN is
connected directly to CPO. 1x mode provides maximum
ef?ciency and minimum noise. The LTC3230 will remain in
pins and by the value of the resistor on the R SET pin.
There are four MLED current sources controlled by the
ENM pin and one SLED current source controlled by the
ENS pin. Full-scale current in the MLED and SLED pins
are set by a resistor from the R SET pin to GND according
to the following formula:
1x mode until any LED current source drops out. Dropout
occurs when a current source voltage becomes too low
for the programmed current to be supplied. When dropout
MLED/SLED Full-Scale Output Current =
0.8
R SETT
? 555
is detected, the LTC3230 will switch into 1.5x mode. The
CPO voltage will then start to increase and will attempt to
reach 1.5x V IN up to 4.5V. Any subsequent dropout will
cause the part to enter 2x mode. The CPO voltage will
attempt to reach 2x V IN up to 5V. The part will be reset to
1x mode whenever the part is shut down or when either
ENM or ENS is driven low.
A 2-phase non-overlapping clock activates the charge pump
switches. In 2x mode the ?ying capacitors are charged on
alternate clock phases from V IN to minimize CPO voltage
ripple. In 1.5x mode the ?ying capacitors are charged in
series during the ?rst clock phase and stacked in parallel
on V IN during the second phase. This sequence of charg-
ing and discharging the ?ying capacitors continues at a
constant frequency of 900kHz.
LED Current Control
The MLED and SLED currents are delivered by program-
mable current sources controlled by the ENM and ENS
Thirty two linear current settings are available by applying
up to 31 pulses when enabling the ENM and ENS pins.
Each strobe counts down a 5-bit DAC to set the LED
current. When the desired count is reached, leave the
enable strobe high and the output current will be set to
the programmed value after a typical delay of 150μs. If
more than 31 strobes are received the counter will stop
at one LSB. The output current will be set to zero if the
enable is set low only after the 150μs delay. If the enable
is toggled before the 150μs delay, the DAC counter will
continue to count down and the current output will not be
enabled until the start-up delay is ?nished.
When both ENM and ENS are held low for more than
250μs (minimum) the LED drivers and charge pump will
go into shutdown. See Figure 1 for timing information. If
the charge pump is in either 1.5x or 2x modes, the falling
edge of either ENM or ENS will reset the charge pump to
1x mode.
ENM OR ENS
LED
CURRENT
SHUTDOWN
t PWH ≥ 200ns
200ns < t PWL < 20 μ s
t EN ≥ 250 μ s
PROGRAMMED
CURRENT
t SD ≥ 250 μ s
ENM = ENS = LOW
3230 F01
Figure 1. Current Programming Timing Diagram
3230fa
9
相关PDF资料
LTC3452EUF#TRPBF IC LED DRIVER PHOTO FLASH 20-QFN
LTC3453EUF#TRPBF IC LED DRIVER PHOTO FLASH 16-QFN
LTC3454EDD#TRPBF IC LED DRIVER PHOTO FLASH 10-DFN
LTC3490EDD#PBF IC LED DRIVER PHOTO FLASH 8-DFN
LTC3783EFE#PBF IC LED DRVR PWM CONTROL 16-TSSOP
LV5026MC-AH IC LED DRIVER 1CH HV 10SOIC
LV5213LP-TE-L-E IC LED DVR 3CH CELL PHONE VCT16
LV5216CS-TE-L-E IC LED DRIVER 10CH CELL 36WLP
相关代理商/技术参数
LTC3230EUD#TRPBF 功能描述:IC LED DRIVR WHITE BCKLGT 20-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极,PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3230EUD-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:5-LED Main/Sub Display Driver with Dual LDO
LTC3230EUD-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:5-LED Main/Sub Display Driver with Dual LDO
LTC3240 制造商:LINER 制造商全称:Linear Technology 功能描述:3.3V/2.5V Step-Up/ Step-Down Charge Pump DC/DC Converter
LTC3240-2.5 制造商:LINER 制造商全称:Linear Technology 功能描述:Wide VIN Range, Low Noise, 250mA Buck-Boost Charge Pump
LTC3240-3.3 制造商:LINER 制造商全称:Linear Technology 功能描述:Wide VIN Range, Low Noise, 250mA Buck-Boost Charge Pump
LTC3240EDC-2.5 制造商:LINER 制造商全称:Linear Technology 功能描述:3.3V/2.5V Step-Up/ Step-Down Charge Pump DC/DC Converter
LTC3240EDC-2.5#TRMPBF 功能描述:IC REG MULTI CONFIG 2.5V 6DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 类型:升压(升压) 输出类型:两者兼有 输出数:1 输出电压:5V,2 V ~ 16.5 V 输入电压:2 V ~ 16.5 V PWM 型:- 频率 - 开关:45kHz 电流 - 输出:50mA 同步整流器:无 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:8-DIP(0.300",7.62mm) 包装:管件 供应商设备封装:8-PDIP